Ultima Bore Gages by Fowler Bowers
A bore with a tolerance in microns needs a gage that reads in fractions of one, at the grinder or in the lab. The Fowler Bowers Ultima resolves to 0.00001″ (0.0001 mm) and covers bores from 0.078″ to 12.2″ (2 to 310 mm), with FASTFIT heads for rapid replacement as the bore size changes. Heads self-center in the bore, and UKAS certificates come standard with every measuring head and setting ring. Choose a set by bore range below, or build a system from individual heads.
How to choose
Range
Start with the bore range, then pick the set
Fowler's Ultima sets cover 0.078″ to 3.94″ (2 to 100 mm) in seven spans, from 0.078″ to 0.236″ (2 to 6 mm) up to 0.787″ to 3.94″ (20 to 100 mm). Each set includes a handle, setting rings, and measuring heads. Choose the 20 to 100 mm set when your bores move between the 20 to 50 and 50 to 100 mm ranges. For bores from 3.94″ to 12.2″ (100 to 310 mm), individual heads and the transducer holder take over.
Reading
Resolution and a readout that fit the station
Ultima resolves to 0.00001″ (0.0001 mm), which leaves room under tolerances in the micron range. Constant spring pressure and self-centering heads give a positive feel and repeatable readings. The readout is sold separately, so you can choose the display that suits the station. Several probe holders can connect to one readout, so a single station can measure different bore sizes.
Heads
Match the head to the feature, not only the diameter
Heads above 0.472″ (12 mm) measure blind bores as standard and carry ceramic anvils. Special heads for grooves, threads, splines, and deep bores are available, and depth stops fit every head. Extensions reach deeper bores. FASTFIT heads replace rapidly, so one handle works across the head ranges in a set.
Common questions
Ultima is built for bores where the tolerance is tight and the reading has to repeat. Bowers lists it for laboratory or shop-floor conditions, and its published case studies describe master gear bores measured in process on internal grinding machines and setting rings verified for a setting master manufacturer. Fowler's sets and heads cover bores from 0.078″ to 12.2″ (2 to 310 mm).
Ultima resolves to 0.00001″ (0.0001 mm). Bowers lists a choice of resolutions up to that figure, so the display can match the tolerance on the print.
No. Each set includes a handle, setting rings, and measuring heads, and the readout is sold separately. Several probe holders can connect to one readout, so different bore sizes can be measured at one station.
Sets run from 0.078″ to 3.94″ (2 to 100 mm) in seven spans, including a 0.787″ to 3.94″ (20 to 100 mm) set for work that crosses two ranges. Above 3.94″ (100 mm), individual heads reach 12.2″ (310 mm) and work with the 3.94″ to 12.2″ (100 to 310 mm) transducer holder. Each listing shows the exact range.
Yes. A bore gage reads against a known diameter, so it's set before use. Ultima setting rings are made to DIN Standard 2250 part 2, and UKAS certificates come standard with every measuring head and setting ring.
Heads above 0.472″ (12 mm) measure blind bores as standard. Special heads for grooves, threads, splines, and deep bores are available, and extensions and depth stops cover deeper bores. All 0.078″ to 0.236″ (2 to 6 mm) sets are supplied with a depth stop.
